Skip to content Skip to navigation menu

PIG® FlexBerm Spill Containment Pad

Ideal For Low Profile, Stays in Place, 10.5' x 18.5' x 2", 200 gal. Sump Capacity
Roll right over the soft foam walls of our flex berm for easy washdowns or temporary leak containment.   Read More 

PRICING (Based on quantity)

$734.00 $698.00


Roll right over the soft foam walls of our flex berm for easy washdowns or temporary leak containment.
  • Pliable, 2"-high foam sidewalls contain liquids and spring back to shape after you roll over them; no ramps or drum lifters needed
  • Double layer, 18 oz. vinyl bottom resists chemicals, punctures and tears
  • One-piece construction deploys in seconds; no assembly required
  • Portable, lightweight and easy to store when not in use
  • 1/2" grommets on each corner help keep the berm in place
  • Yellow outer berm is easy to see
  • Ideal as a flexible solution for drum or battery storage, equipment washdowns or vehicle maintenance
  • Not recommended for use with vehicle traffic


Traffic Cart Traffic
Color Yellow
Dimensions 10.5' W x 18.5' L x 2" H
Sump Capacity 200 gal.
Brand PIG
Folded Dimensions 2.67' W x 2.67' L x 1.63' H Folded
Ideal For Low Profile, Stays in Place
Sold as 1 each
Weight 42 lbs.
# per Pallet 3
Composition 18 oz. Vinyl
Sump Dimensions 10' W x 18' L x 2" H
UNSPSC 24111812
Pigalog® Page Number Page 393


Based on 1 reviews

By Michael


Flexberm Spill containment pad

Seems to be very good quality. Im sure it will handle the job for years. Besides the fact of holding over 200 gallons. I don't have to worry about spills anymore from my forklifts and staining the concrete and causing more work.. I can rate it a 5 at this point and will adjust in the future if I see any different.

Additional Information

  • Chemical Compatibility for FlexBerm Containment Pads
  • How to Measure for PIG® Collapse-a-tainer® Containment System
  • 40 CFR 112.7
    SPCC planning requirements state that facilities subject to these regulations must have written plans in place discussing the products, countermeasures and procedures that are in place, or will be taken by the facility to prevent discharge of oil into waters of the United States.
  • 40 CFR 122.26
    When applying for a National Pollutant Discharge Elimination System (NPDES) permit, facilities must have a plan in place that describes actions, procedures, control techniques, management practices and equipment available to prevent illegal discharge of pollutants into waterways.
  • 40 CFR 264.175
    Hazardous waste containment systems must be free of structural cracks or gaps, be designed to keep spilled liquids from remaining in contact with the container, prevent run-on and "have sufficient capacity to contain 10% of the volume of the containers, or the volume of the largest container, whichever is greater."
Contact Us