Skip to content Skip to navigation menu

PIG® FlexBerm Spill Containment Pad

Ideal For Low Profile, Stays in Place, 2.7' x 4.7' x 2", 10 gal. Sump Capacity
Roll right over the soft foam walls of our flex berm for easy washdowns or temporary leak containment.   Read More 

PRICING (Based on quantity)

$174.00 $163.00
This product has accessories — take a look 


Roll right over the soft foam walls of our flex berm for easy washdowns or temporary leak containment.
  • Soft, 2" sidewalls contain liquids and spring back to shape after you roll over them; no ramps or drum lifters needed
  • Ready-to-use berm is ideal for temporary storage of drums and containers
  • Constructed of leakproof, impermeable and chemical-resistant 18 oz. vinyl
  • One-piece construction deploys in seconds; no assembly required
  • Portable, lightweight and easy to store when not in use
  • Bright yellow color minimizes tripping hazards
  • Not recommended for use with vehicle traffic
  • Use Deck Grates (PAK354) for stepping or to elevate drums off the berm


Traffic Cart Traffic
Dimensions 2.7' W x 4.7' L x 2" H
Sump Capacity 10 gal.
Brand PIG
Folded Dimensions 2' W x 2' L x 4" H Folded
Ideal For Low Profile, Stays in Place
Sold as 1 each
Weight 9 lbs.
# per Pallet 15
Composition 18 oz. Vinyl
Sump Dimensions 2' W x 4' L x 2" H
UNSPSC 24111812
Pigalog® Page Number Page 399

Accessories for PAK724


Based on 1 reviews

By Paul



The mat does the job it is designed to do but our problem cannot be solver completely by using this mat. The problem is that mixes drip out of the hose during connect and disconnect and we need to provide shut off valves in the lines to prevent any backflow. The area where the dripping is occurring is "T" shaped and this mat only addresses the top portion of the "T".

Additional Information

  • Chemical Compatibility for PIG Build-A-Berm® Barrier
  • How to Measure for PIG® Collapse-a-tainer® Containment System
  • 40 CFR 112.7
    SPCC planning requirements state that facilities subject to these regulations must have written plans in place discussing the products, countermeasures and procedures that are in place, or will be taken by the facility to prevent discharge of oil into waters of the United States.
  • 40 CFR 122.26
    When applying for a National Pollutant Discharge Elimination System (NPDES) permit, facilities must have a plan in place that describes actions, procedures, control techniques, management practices and equipment available to prevent illegal discharge of pollutants into waterways.
  • 40 CFR 264.175
    Hazardous waste containment systems must be free of structural cracks or gaps, be designed to keep spilled liquids from remaining in contact with the container, prevent run-on and "have sufficient capacity to contain 10% of the volume of the containers, or the volume of the largest container, whichever is greater."
Contact Us