Skip to content Skip to navigation menu

PIG® Pallet Rack Containment Sump

Holds (4) 55 gal. Plastic or Steel Drums or (1) IBC, 66 gal. Sump Capacity
As Low As $403.00
Economical polyethylene sump drops right into your existing rack system to add secondary containment for stored drums.   Read More 

Please choose an option to see pricing.

$403.00 - $431.00


Economical polyethylene sump drops right into your existing rack system to add secondary containment for stored drums.
  • Holds almost any wood, poly or metal pallet above sump without expensive grating; strong enough to support four fully loaded drums or even a single IBC
  • Sump catches leaks, drips and spills to help you comply with regulations and keep your storage areas clean and safe; allows vertical segregation of incompatible materials to save floor space
  • Low-density polyethylene (LDPE) construction resists UV rays, rust, corrosion and most chemicals
  • Drops right into steel pallet racks from 36" to 48" deep; no special installation, hardware or grating required
  • Low-profile lip doesn't block forklift access to pallet
  • Nestable design permits stacking when not in use to save space; lowers cost of bulk shipping
  • Increase sump capacity by connecting additional units using bulkhead fittings (sold separately)
  • Optional drain plug lets you empty sump without removing from rack


Holds (4) 55 gal. Plastic or Steel Drums or (1) IBC
Color Yellow
Dimensions 52" W x 52" L x 11.5" H
Load Capacity UDL 3000 lbs.
Sump Capacity 66 gal.
Drain Includes Drain
Fork Truck Access No Fork Truck Access
Grates No Grate
Use With Flammables No
Sold as 1 each
Weight 44 lbs.
# per Pallet 10
Composition LDPE
UNSPSC 24111812
Pigalog® Page Number Page 389


Additional Information

  • Chemical Compatibility for LDPE Products
  • 40 CFR 112.7
    SPCC planning requirements state that facilities subject to these regulations must have written plans in place discussing the products, countermeasures and procedures that are in place, or will be taken by the facility to prevent discharge of oil into waters of the United States.
  • 40 CFR 122.26
    When applying for a National Pollutant Discharge Elimination System (NPDES) permit, facilities must have a plan in place that describes actions, procedures, control techniques, management practices and equipment available to prevent illegal discharge of pollutants into waterways.
  • 40 CFR 264.175
    Hazardous waste containment systems must be free of structural cracks or gaps, be designed to keep spilled liquids from remaining in contact with the container, prevent run-on and "have sufficient capacity to contain 10% of the volume of the containers, or the volume of the largest container, whichever is greater."
Contact Us